Sinterit Support

FAQ (Frequently Asked Questions)

Why is one edge of the printout slightly turned up or bent?
This occurs due to material shrinkage and is difficult to eliminate in this technology if one edge is parallel to the base of the workspace. In order to avoid this, turn the model at least 20 degrees in the X axis. If the problem persists, also rotate the model in the Y axis.

The powder behaves like damp dust (is not as loose as it should) which makes spreading the first layer difficult. Will the prints be ok?
Do not get discouraged. The printout will most definitely come out fine, as any dampness that may be contained in the powder because of its hygroscopicity will be immediately vaporised during the warm-up and printing of the machine. Spreading of the first layer will simply be slightly more onerous and take more time.

Why is the surface slightly wavy following the recoater passage, instead of smooth like usual?
The recoater roller has probably stopped rotating. In order to fix this, apply two drops of oil to each of the recoater bearings (at both sides). Another reason that may have caused this: the recoater transmission rope (responsible for its rotation) may have broken. This is easy to ascertain as one of the strands that is always located by the recoater will simply be broken in such case. This will be visible to the naked eye, in which case replace the strand.

The printouts are weak, very brittle and porous.
The powder has not been refreshed properly and has aged. Use new powder or add at least 50% of the so-called ‘fresh powder’.

Why is a model which has been intended as movable immovable upon printout/cannot be set in motion?
The gaps between the pins and the rotating elements have been too narrow. Increase the gaps in the model.

I am unable to clean the printout – it is submerged in compact powder.
The pyrometer sight glasses have probably not been cleaned properly. Use a cloth saturated with spirit to wipe them thoroughly. This should remove the problem.

Sinterit Video Library:

Video library: Lisa PRO

Powder maintenance for Sinterit SLS 3D printers

Cleaning Sinterit Lisa Pro 3D printer

Replacing the recoater cord in Sinterit Lisa Pro

Video library: Lisa

First activation of the Sinterit Lisa printer

Sinterit Lisa 3D SLS printer description

The exemplary package Sinterit Lisa contains

Filling the device with powder | Sinterit Lisa

Cleaning the print | Sinterit Lisa

Two printing materials PA12 Smooth and Flexa Black: application and usage

Refreshing the powder with Powder Sieve | Sinterit Lisa

Replacing the cord | Sinterit Lisa